Eco Plus

MCX Series

Eco-Plus Series
Eco-Plus Series
Chamfering Endmill

Finish
Rough
 
Steel
Stainless Steel
Hardened Steel ≤ 54 HRc
Hardened Steel > 54 HRc
Cast
Graphite
Non Ferrous Material
HRSA
Titanium
  • Recommended
  • Acceptable
  • Not Recommended

MCX Series

StockOrder No.CodeOld Coded1h6d2h6l1l2αZRelated Document
*39100MCX.4.0400.0500.A090.0100.0000.0000.00.S04A1A01.01MCX404051445010904
*39102MCX.4.0600.0580.A090.0120.0000.0000.00.S06A1A01.01MCX406058665812904
*39104MCX.5.0800.0640.A090.0150.0000.0000.00.S08A1A01.01MCX508064886415905
*39106MCX.6.1000.0730.A090.0140.0000.0000.00.S10A1A01.01MCX61007310107314906
*39108MCX.6.1200.0820.A090.0140.0000.0000.00.S12A1A01.01MCX61208212128214906

Feed Per Tooth (mm/tooth)

Ø ae=0,1xØ ap=0,1xØ
4 0,05-0,11
6 0,06-0,15
8 0,08-0,2
10 0,1-0,26
12 0,1-0,26
14 0,1-0,26
16 0,12-0,26
20 0,16-0,44

Cutting Parameters

Material Quarter Circle
Vc (m/min) 
Unalloyed steel 280-320
Steel 220-250
Tempered steel 190-220
Cold work tool steel 100-130
Hot work tool steel 100-130
AISI 304 - 416 - 420 80-110
AISI 316 - 440 80-110
17-4 PH 15-5 PH 60-90
Chrome-Cobalt alloy 60-90
Duplex F51 50-70
Super duplex F55 50-70
Gray cast Iron 200-240
Alloyed Cast Iron 200-240
Precision Cast Iron 180-215
Aluminum Alloys 230-370
Copper Alloys 650-680
Iron-Based Super Alloys 40-50
Nickel-Based Super Alloys 40-50
Titanium-Based Super Alloys 70-90
Steel
Stainless Steel
Hardened Steel ≤ 54 HRc
Hardened Steel > 54 HRc
Cast
Graphite
Non Ferrous Material
HRSA
Titanium
  • Recommended
  • Acceptable
  • Not Recommended